APRS Track Direct

My position About ☰

reset

E25ZZZ Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E25ZZZ. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1836274562	-56 dBm	0.43 V
1778049897	-52 dBm	0.45 V
1778048973	-54 dBm	0 V
1778048049	-56 dBm	0.31 V
1778047125	-55 dBm	0.06 V
1778046200	-53 dBm	0.04 V
1778045276	-56 dBm	0.06 V
1778044352	-58 dBm	0.1 V
1778043428	-56 dBm	0.35 V
1778042504	-56 dBm	0.02 V
1778041579	-54 dBm	0.27 V
1778040655	-57 dBm	0.06 V
1778039731	-52 dBm	0.41 V
1778038807	-55 dBm	0.27 V
1778037883	-53 dBm	0.04 V
1778036959	-54 dBm	0.06 V
1778036034	-57 dBm	0 V
1778035110	-55 dBm	0.1 V
1778034186	-57 dBm	0.31 V
1778033262	-55 dBm	0.14 V
1778032338	-55 dBm	0.06 V
1778031414	-54 dBm	0.35 V
1778030490	-54 dBm	0.49 V
1778029565	-57 dBm	0 V
1778028641	-53 dBm	0.39 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)