APRS Track Direct

My position About ☰

reset

CR7BQX-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758212203	212 Count	591 Count
1758210397	210 Count	585 Count
1758208591	208 Count	580 Count
1758206786	206 Count	574 Count
1758204980	204 Count	568 Count
1758203174	202 Count	562 Count
1758201368	200 Count	556 Count
1758199562	198 Count	550 Count
1758197756	196 Count	544 Count
1758195950	194 Count	538 Count
1758194214	188 Count	531 Count
1758192408	186 Count	525 Count
1758190602	184 Count	512 Count
1758188797	182 Count	506 Count
1758186991	180 Count	500 Count
1758185185	178 Count	494 Count
1758183379	176 Count	488 Count
1758181573	174 Count	482 Count
1758179767	172 Count	476 Count
1758177961	170 Count	470 Count
1758176156	168 Count	464 Count
1758174350	166 Count	458 Count
1758170807	158 Count	447 Count
1758169001	156 Count	434 Count
1758167195	154 Count	428 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)