APRS Track Direct

My position About ☰

reset

ED1ZAE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED1ZAE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1754163655	32	19	73	176	169
1754162456	33	19	73	176	170
1754162455	33	19	73	176	170
1754161255	33	18	72	176	170
1754160656	33	18	72	176	170
1754160055	34	20	72	176	170
1754158856	37	22	72	176	170
1754158855	37	22	72	176	170
1754157655	40	23	72	176	170
1754157056	41	23	72	176	170
1754156455	39	21	72	176	170
1754155256	36	20	72	176	171
1754155255	36	20	72	176	171
1754154055	36	20	72	176	171
1754153456	37	21	72	176	170
1754152855	39	22	72	175	170
1754151657	44	22	72	176	170
1754151655	44	22	72	176	170
1754150455	39	20	72	176	170
1754149858	38	21	72	176	171
1754149255	39	22	72	176	171
1754148056	40	24	72	176	171
1754148055	40	24	72	176	171
1754146855	44	26	72	176	172
1754146256	47	26	72	176	172

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)