APRS Track Direct

My position About ☰

reset

SP2DRP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2DRP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1790648791	208 Count	411 Count	160 Count
1790646991	193 Count	382 Count	149 Count
1790645190	177 Count	349 Count	137 Count
1790643390	161 Count	314 Count	125 Count
1790641589	144 Count	280 Count	112 Count
1790639788	127 Count	250 Count	99 Count
1790637988	110 Count	213 Count	86 Count
1790636187	95 Count	181 Count	75 Count
1790634386	74 Count	139 Count	58 Count
1790632586	53 Count	96 Count	41 Count
1790630785	37 Count	68 Count	29 Count
1790629002	19 Count	37 Count	16 Count
1790627201	493 Count	1010 Count	373 Count
1790625401	476 Count	982 Count	360 Count
1790623600	460 Count	948 Count	348 Count
1790621799	445 Count	912 Count	337 Count
1790619999	428 Count	882 Count	324 Count
1790618198	413 Count	852 Count	313 Count
1790616397	397 Count	818 Count	301 Count
1790614597	380 Count	786 Count	288 Count
1790612796	341 Count	740 Count	274 Count
1790610995	294 Count	661 Count	248 Count
1790609195	266 Count	601 Count	224 Count
1790608138	251 Count	577 Count	211 Count
1790606338	216 Count	495 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)