APRS Track Direct

My position About ☰

reset

BD7MOV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BD7MOV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	CpuTemp*	Temp*
1758182539	59.1 C	33.9 C
1758181938	58.9 C	33.8 C
1758181338	59.3 C	33.8 C
1758180738	59.1 C	33.6 C
1758180138	58.9 C	33.3 C
1758179539	59.3 C	33.2 C
1758178939	58.5 C	33 C
1758178339	58.2 C	32.8 C
1758177739	57.2 C	32.5 C
1758177138	58.4 C	32.3 C
1758176538	57.7 C	32.1 C
1758175938	57.9 C	31.9 C
1758175338	56 C	31.7 C
1758174738	57 C	31.4 C
1758174139	56.7 C	31.3 C
1758173539	56.8 C	31.1 C
1758172939	56 C	30.9 C
1758172339	56.6 C	30.7 C
1758171738	55.5 C	30.6 C
1758171138	55.6 C	30.5 C
1758170538	56 C	30.3 C
1758169938	54.8 C	30.2 C
1758169338	56 C	30.1 C
1758168739	55 C	30 C
1758168139	55.3 C	29.9 C

*Used Equation Coefficients:

CpuTemp: 0, 0.1, 0

Temp: 0, 0.1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)