APRS Track Direct

My position About ☰

reset

SP3KAU-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KAU-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790638208	49 Count	361 Count	32 Count
1790636407	46 Count	353 Count	30 Count
1790634605	42 Count	344 Count	27 Count
1790632803	39 Count	336 Count	25 Count
1790629200	33 Count	321 Count	21 Count
1790627399	29 Count	299 Count	18 Count
1790625598	25 Count	282 Count	15 Count
1790623796	21 Count	236 Count	12 Count
1790621995	18 Count	193 Count	10 Count
1790620212	14 Count	165 Count	7 Count
1790618411	11 Count	103 Count	5 Count
1790616610	3 Count	47 Count	2 Count
1790614808	66 Count	1050 Count	44 Count
1790613007	62 Count	988 Count	41 Count
1790611206	59 Count	943 Count	39 Count
1790609404	55 Count	902 Count	37 Count
1790607602	52 Count	821 Count	35 Count
1790605801	48 Count	743 Count	32 Count
1790604000	40 Count	673 Count	29 Count
1790602198	36 Count	610 Count	26 Count
1790600397	33 Count	546 Count	24 Count
1790598610	29 Count	502 Count	21 Count
1790596808	26 Count	442 Count	19 Count
1790595007	22 Count	389 Count	16 Count
1790593206	18 Count	310 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)