APRS Track Direct

My position About ☰

reset

HB4FV-24 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB4FV-24. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790641149	214 Count	148 Count	146 Count
1790637543	208 Count	144 Count	142 Count
1790635740	205 Count	142 Count	140 Count
1790633937	202 Count	140 Count	138 Count
1790632134	198 Count	137 Count	135 Count
1790630331	194 Count	134 Count	132 Count
1790628528	191 Count	132 Count	130 Count
1790626725	188 Count	130 Count	128 Count
1790624922	185 Count	128 Count	126 Count
1790623119	182 Count	126 Count	124 Count
1790621316	179 Count	124 Count	122 Count
1790619513	175 Count	121 Count	119 Count
1790617710	172 Count	119 Count	117 Count
1790615907	169 Count	117 Count	115 Count
1790614104	166 Count	115 Count	113 Count
1790612301	162 Count	112 Count	110 Count
1790610498	159 Count	110 Count	108 Count
1790608838	152 Count	108 Count	106 Count
1790607034	149 Count	106 Count	104 Count
1790605232	146 Count	104 Count	102 Count
1790603428	143 Count	102 Count	100 Count
1790601625	140 Count	100 Count	98 Count
1790599822	137 Count	98 Count	96 Count
1790598019	134 Count	96 Count	94 Count
1790596216	131 Count	94 Count	92 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)