APRS Track Direct

My position About ☰

reset

YS2HE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YS2HE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749328342	51	145	255	69	58
1749327140	51	144	255	69	59
1749325939	51	142	255	70	59
1749324731	51	140	255	71	61
1749323530	50	139	255	73	62
1749322328	51	138	255	74	64
1749321127	51	139	255	73	63
1749319926	51	139	255	72	62
1749318724	50	140	255	72	62
1749317522	50	139	255	73	63
1749316321	51	139	255	73	63
1749315119	50	139	255	73	62
1749313918	51	139	255	73	63
1749312716	51	140	255	72	62
1749311515	51	140	255	72	61
1749310313	51	139	255	73	63
1749309112	51	136	255	74	64
1749307910	50	133	255	75	66
1749306705	50	132	255	77	68
1749305503	50	129	255	79	70
1749304302	50	126	255	80	71
1749303101	50	124	255	82	74
1749301899	50	121	255	83	76
1749300698	50	118	255	84	77
1749299496	50	118	255	85	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)