APRS Track Direct

My position About ☰

reset

E25WPV-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E25WPV-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	VBAT*
1790660985	-58 dbm	11.82 V
1790660685	-60 dbm	11.84 V
1790660385	-63 dbm	11.83 V
1790660085	-62 dbm	11.81 V
1790659785	-65 dbm	11.88 V
1790659484	-65 dbm	11.84 V
1790659185	-68 dbm	11.82 V
1790658885	-61 dbm	11.85 V
1790658584	-65 dbm	11.83 V
1790658285	-62 dbm	11.86 V
1790657985	-60 dbm	11.84 V
1790657384	-66 dbm	11.81 V
1790657084	-69 dbm	11.83 V
1790656784	-70 dbm	11.83 V
1790656484	-66 dbm	11.88 V
1790656185	-64 dbm	11.84 V
1790655884	-57 dbm	11.83 V
1790655584	-65 dbm	11.8 V
1790655284	-61 dbm	11.82 V
1790654984	-66 dbm	11.86 V
1790654684	-61 dbm	11.81 V
1790654384	-56 dbm	11.83 V
1790653784	-60 dbm	11.82 V
1790653484	-62 dbm	11.83 V
1790653184	-66 dbm	11.88 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

AQI: 0, 1, 0

PM2.5: 0, 1, 0

PM10: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)