APRS Track Direct

My position About ☰

reset

SP9DRM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DRM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1749401703	384 Count	67 Count	49 Count
1749399903	383 Count	67 Count	49 Count
1749398103	382 Count	67 Count	49 Count
1749396302	381 Count	67 Count	49 Count
1749394502	380 Count	67 Count	49 Count
1749392710	379 Count	67 Count	49 Count
1749390910	378 Count	67 Count	49 Count
1749389109	377 Count	67 Count	49 Count
1749387309	376 Count	67 Count	49 Count
1749378302	367 Count	64 Count	46 Count
1749376501	366 Count	64 Count	46 Count
1749374700	365 Count	64 Count	46 Count
1749372900	364 Count	64 Count	46 Count
1749371101	363 Count	64 Count	46 Count
1749369300	362 Count	64 Count	46 Count
1749367499	360 Count	63 Count	45 Count
1749365699	359 Count	63 Count	45 Count
1749363901	358 Count	63 Count	45 Count
1749362100	357 Count	63 Count	45 Count
1749360300	356 Count	63 Count	45 Count
1749358499	355 Count	63 Count	45 Count
1749356700	354 Count	63 Count	45 Count
1749354899	353 Count	63 Count	45 Count
1749353099	352 Count	63 Count	45 Count
1749351298	351 Count	63 Count	45 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)