APRS Track Direct

My position About ☰

reset

IN3EJX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IN3EJX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790642340	58 Count	537 Count
1790640536	57 Count	528 Count
1790638733	56 Count	518 Count
1790636929	55 Count	509 Count
1790635125	54 Count	499 Count
1790633322	53 Count	490 Count
1790631558	48 Count	481 Count
1790629754	47 Count	471 Count
1790627951	46 Count	461 Count
1790626147	45 Count	451 Count
1790624344	44 Count	442 Count
1790622540	43 Count	431 Count
1790620737	42 Count	421 Count
1790618933	41 Count	411 Count
1790617130	40 Count	398 Count
1790615326	39 Count	385 Count
1790613522	38 Count	374 Count
1790611719	37 Count	359 Count
1790609955	32 Count	339 Count
1790608151	31 Count	322 Count
1790606348	30 Count	304 Count
1790604544	29 Count	281 Count
1790602741	28 Count	262 Count
1790600937	27 Count	247 Count
1790599134	26 Count	227 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)