APRS Track Direct

My position About ☰

reset

ZL1ROT-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL1ROT-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1836274658	136	19	533	592
1762314086	136	30	531	573
1762313185	136	30	526	573
1762312284	136	29	532	573
1762311380	136	29	530	571
1762310479	136	29	527	567
1762309578	136	29	526	565
1762308677	136	29	531	565
1762307777	143	28	533	563
1762306876	139	28	533	563
1762305968	143	27	540	569
1762305068	139	27	533	566
1762304164	143	26	535	569
1762303263	143	26	540	568
1762302362	143	25	536	565
1762301461	143	25	537	567
1762300557	143	24	535	571
1762299656	143	23	534	571
1762298754	143	23	541	554
1762297850	143	22	533	510
1762296950	138	20	537	499
1762296048	137	19	534	495
1762295148	135	18	529	494
1762294246	134	17	528	492
1762293346	133	16	526	490

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)