APRS Track Direct

My position About ☰

reset

VK4ZZ-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4ZZ-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1791771299	161	173	216	226	166
1791767698	161	174	216	218	149
1791764096	161	176	220	238	167
1791760493	160	176	179	196	123
1791756891	159	174	214	229	169
1791753290	158	174	217	221	149
1791749687	157	173	217	221	172
1791746086	157	173	220	237	180
1791742484	157	173	217	220	172
1791738883	157	173	210	229	148
1791735280	158	174	218	235	178
1791731679	158	174	221	238	182
1791728077	158	174	218	222	157
1791724476	158	174	214	223	173
1791720874	158	175	219	230	164
1791717273	158	188	224	243	171
1791717079	158	192	230	234	171
1791713470	159	175	212	209	159
1791709868	158	185	217	234	177
1791709679	158	183	218	233	167
1791709432	159	185	220	237	178
1791709229	159	194	216	213	153
1791707981	159	175	222	240	181
1791704379	160	175	104	85	59
1791700778	160	176	223	241	151

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)