APRS Track Direct

My position About ☰

reset

YB2WYC-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB2WYC-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1790009679	-56 dBm	8.29 V
1790009053	-61 dBm	8.02 V
1790008428	-56 dBm	8.06 V
1790007803	-56 dBm	8.04 V
1790007178	-54 dBm	8.43 V
1790006553	-55 dBm	8.31 V
1790005928	-65 dBm	7.92 V
1790005302	-59 dBm	7.92 V
1790004677	-58 dBm	8.43 V
1790004052	-59 dBm	7.92 V
1790003427	-60 dBm	7.98 V
1790002802	-58 dBm	8.37 V
1790002177	-59 dBm	8.37 V
1790001552	-55 dBm	8.53 V
1790000927	-54 dBm	7.63 V
1790000301	-56 dBm	14.54 V
1789999676	-57 dBm	14.52 V
1789999050	-48 dBm	14.48 V
1789998425	-53 dBm	14.48 V
1789997800	-46 dBm	14.48 V
1789997175	-57 dBm	14.44 V
1789996550	-61 dBm	14.38 V
1789995924	-60 dBm	14.38 V
1789995299	-59 dBm	10.42 V
1789994674	-56 dBm	7.81 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)