APRS Track Direct

My position About ☰

reset

E24TVS-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E24TVS-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1790655479	-36 dBm	13.1 V
1790654257	-35 dBm	13.08 V
1790652999	-35 dBm	12.96 V
1790651777	-33 dBm	13.08 V
1790650555	-35 dBm	12.98 V
1790649333	-34 dBm	13.08 V
1790648142	-35 dBm	12.96 V
1790646889	-35 dBm	13.1 V
1790645667	-34 dBm	13.08 V
1790644445	-35 dBm	13.08 V
1790643223	-35 dBm	12.98 V
1790642001	-35 dBm	12.98 V
1790640779	-35 dBm	13.08 V
1790639557	-35 dBm	12.98 V
1790638335	-35 dBm	13.1 V
1790637113	-35 dBm	13.1 V
1790635891	-35 dBm	12.98 V
1790634669	-35 dBm	12.98 V
1790633447	-34 dBm	13.1 V
1790632225	-35 dBm	13.1 V
1790631003	-35 dBm	13 V
1790629781	-34 dBm	12.98 V
1790628559	-35 dBm	13 V
1790627337	-35 dBm	13 V
1790626115	-34 dBm	12.98 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)