APRS Track Direct

My position About ☰

reset

BV2CW-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BV2CW-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	CPUTemp*	DiGi*
1732462804	37.2 C	60 p
1732461604	36.3 C	58 p
1732460404	36.9 C	58 p
1732459205	36.6 C	58 p
1732458005	37.7 C	58 p
1732456804	37.1 C	58 p
1732455604	36.7 C	58 p
1732454405	37.1 C	58 p
1732453204	37.4 C	58 p
1732452004	36.5 C	58 p
1732450804	37.8 C	58 p
1732449604	37.6 C	58 p
1732448404	35.6 C	58 p
1732447204	36.5 C	58 p
1732446004	36.2 C	58 p
1732444805	36.5 C	58 p
1732443605	35.7 C	58 p
1732442405	36.6 C	58 p
1732441204	37.6 C	54 p
1732440004	37.3 C	48 p
1732438804	36.5 C	42 p
1732437605	36.7 C	36 p
1732436404	37.6 C	32 p
1732435204	36.6 C	29 p
1732434004	36.3 C	25 p

*Used Equation Coefficients:

CPUTemp: 0, 1, 0

RxPkts/20m: 0, 1, 0

RxPkts/1h: 0, 1, 0

RxPkts/24h: 0, 1, 0

DiGi: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)