APRS Track Direct

My position About ☰

reset

JR2YQN-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JR2YQN-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274723	134	75	255	104	90
1778061342	134	61	255	116	101
1778060441	134	61	255	104	88
1778060404	134	61	255	116	100
1778059503	134	62	255	115	100
1778058601	134	62	255	115	100
1778056760	134	63	255	115	99
1778055858	134	63	255	115	100
1778054957	134	63	255	115	99
1778054055	134	63	255	115	99
1778053154	134	64	255	104	87
1778053114	134	64	255	114	99
1778052212	134	65	255	114	98
1778051311	134	65	255	113	97
1778050409	134	66	255	113	97
1778049508	134	66	255	104	87
1778049465	134	66	255	112	97
1778047662	134	67	255	112	96
1778046761	134	68	255	111	96
1778045859	134	68	255	103	87
1778045814	134	68	255	111	95
1778044912	134	69	255	110	95
1778044011	134	69	255	110	94
1778043109	134	69	255	110	94
1778042207	134	69	255	103	87

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)