APRS Track Direct

My position About ☰

reset

SR0L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR0L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*
1732541426	203	27	181	158
1732537645	198	27	180	160
1732534503	202	27	181	160
1732533875	214	27	182	159
1732532617	230	27	185	161
1732529468	233	27	185	161
1732527581	241	27	186	160
1732526952	239	27	186	160
1732526323	253	27	188	161
1732525694	246	27	187	157
1732525065	248	27	188	160
1732524436	245	27	187	160
1732523178	250	27	188	160
1732522549	249	27	188	160
1732518763	0	28	189	160
1732516252	9	28	190	159
1732513097	251	27	188	160
1732512468	251	27	188	160
1732511839	234	27	185	159
1732510581	237	27	186	159
1732509953	229	27	185	160
1732509315	205	27	181	160
1732506170	96	27	165	160

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)