APRS Track Direct

My position About ☰

reset

OE5XDO-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE5XDO-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	U-Netz*	U-Akku*
1836274821	13.59 V	13.57 V
1836274521	13.6 V	13.57 V
1836274371	13.6 V	13.57 V
1836274226	13.6 V	13.57 V
1836273922	13.64 V	13.57 V
1762240509	13.62 V	13.02 V
1762240209	13.6 V	13.02 V
1762239909	13.6 V	13.02 V
1762239610	13.6 V	13 V
1762239310	13.6 V	13.02 V
1762239010	13.6 V	13.02 V
1762238711	13.6 V	13.02 V
1762238414	13.57 V	13.02 V
1762238112	13.6 V	13.02 V
1762237812	13.59 V	13.02 V
1762237512	13.6 V	13.02 V
1762237213	13.6 V	13.02 V
1762236913	13.6 V	13.02 V
1762236614	13.57 V	13.02 V
1762236314	13.6 V	13.04 V
1762236014	13.59 V	13.02 V
1762235715	13.6 V	13.02 V
1762235415	13.57 V	13.04 V
1762235115	13.6 V	13.04 V
1762234816	13.59 V	13.02 V

*Used Equation Coefficients:

U-Netz: 0, 0.01, 0

U-Akku: 0, 0.01, 0

STBY: 0, 1, 0

BUSY: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)