APRS Track Direct

My position About ☰

reset

PVLY Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PVLY. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790660025	154	72	16	73	132
1790659125	154	74	17	73	132
1790658223	154	75	17	75	132
1790657322	154	78	19	74	132
1790656421	154	82	21	74	132
1790655521	154	82	22	73	132
1790654620	154	88	25	71	132
1790653719	154	91	25	72	132
1790652820	155	91	25	72	132
1790651918	155	93	25	72	132
1790651016	155	98	26	71	132
1790650115	155	97	26	71	132
1790649218	155	99	27	71	132
1790648314	155	95	25	71	132
1790647413	155	88	24	72	132
1790646520	155	80	21	71	132
1790645616	156	80	21	72	132
1790644710	156	87	24	73	132
1790643812	156	95	25	73	132
1790642909	156	101	26	74	132
1790642008	157	103	27	74	132
1790641158	158	96	25	73	132
1790641107	-	-	-	-	-
1790641107	158	96	25	73	132
1790640206	158	87	23	73	132

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)