APRS Track Direct

My position About ☰

reset

K5NOT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K5NOT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790630490	130	98	128	104	88
1790626894	130	97	127	103	85
1790623299	130	96	128	103	87
1790619704	130	94	129	105	88
1790616108	130	91	129	106	91
1790612512	130	88	129	106	91
1790608917	130	85	128	106	92
1790605321	130	83	129	107	93
1790601726	130	82	128	106	92
1790598131	130	82	128	106	92
1790594535	130	83	128	107	91
1790590940	130	84	129	107	91
1790587345	129	85	128	106	90
1790583749	130	85	128	106	90
1790580154	130	87	128	106	91
1790576557	130	88	129	107	90
1790572961	130	89	128	106	90
1790569366	130	90	129	106	90
1790565770	130	91	127	105	88
1790562174	130	93	129	105	89
1790558579	130	96	128	104	88
1790554984	130	97	128	103	86
1790551388	130	98	129	104	86
1790547793	130	100	128	104	86

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)