APRS Track Direct

My position About ☰

reset

ED5YAM Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAM. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274793	498	598	999	84	499
1836274613	498	599	999	109	499
1836274583	498	598	999	100	499
1836274433	498	598	999	116	498
1836274403	498	598	999	91	498
1836274250	498	599	999	88	498
1836274223	498	598	999	96	499
1836274069	498	599	999	99	499
1836273889	498	599	999	98	499
1778044279	495	582	999	46	499
1778044096	495	582	999	29	499
1778043916	491	581	999	29	498
1778043736	491	582	999	11	498
1778043556	491	582	999	4	498
1778043376	491	582	999	29	498
1778043195	491	582	999	63	498
1778043015	491	582	999	3	498
1778042835	491	582	999	28	498
1778042655	491	582	999	14	498
1778042475	491	582	999	4	498
1778042292	491	582	999	4	498
1778042112	491	582	999	4	498
1778041932	491	582	999	4	498
1778041752	491	582	999	4	498
1778041571	491	582	999	4	498

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)