APRS Track Direct

My position About ☰

reset

F5YH Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5YH. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790662320	151	196	214	230	176
1790661710	151	196	215	231	171
1790659894	151	196	215	231	177
1790658077	151	196	211	218	170
1790656869	151	196	210	221	171
1790656265	151	196	210	221	171
1790655049	151	196	210	223	174
1790654444	151	196	214	230	176
1790650808	151	196	214	225	171
1790650204	151	196	214	231	176
1790648993	151	196	211	224	176
1790647179	151	196	212	224	159
1790643542	151	196	213	225	161
1790642937	151	196	211	225	166
1790642331	151	196	210	221	171
1790641724	151	196	213	229	172
1790641120	152	196	211	216	160
1790640515	152	196	211	222	174
1790639909	152	196	212	227	168
1790638700	152	196	210	221	164
1790638092	152	196	213	224	180
1790637485	152	196	211	219	171
1790636881	152	196	214	224	163
1790636275	152	196	213	221	170
1790634458	152	196	214	225	171

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)