APRS Track Direct

My position About ☰

reset

IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1790649627	56 Count	183 Count	52 Count
1790646020	31 Count	109 Count	29 Count
1790642414	12 Count	40 Count	12 Count
1790638807	375 Count	969 Count	347 Count
1790635201	350 Count	897 Count	324 Count
1790631594	323 Count	828 Count	299 Count
1790628034	297 Count	760 Count	275 Count
1790624423	271 Count	689 Count	251 Count
1790620815	243 Count	601 Count	225 Count
1790617208	216 Count	533 Count	200 Count
1790613601	188 Count	480 Count	174 Count
1790609995	162 Count	432 Count	150 Count
1790606427	137 Count	362 Count	127 Count
1790602821	111 Count	293 Count	103 Count
1790599214	84 Count	223 Count	78 Count
1790595607	59 Count	149 Count	55 Count
1790592000	29 Count	69 Count	27 Count
1790588394	0 Count	0 Count	0 Count
1790584826	377 Count	958 Count	349 Count
1790581220	353 Count	895 Count	327 Count
1790577611	327 Count	830 Count	303 Count
1790574004	299 Count	761 Count	277 Count
1790570397	273 Count	692 Count	253 Count
1790566791	248 Count	628 Count	230 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)