APRS Track Direct

My position About ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1790645530	156 Count	805 Count	135 Count
1790644329	139 Count	718 Count	121 Count
1790643128	125 Count	610 Count	108 Count
1790641928	107 Count	522 Count	94 Count
1790640727	82 Count	411 Count	72 Count
1790639526	62 Count	314 Count	55 Count
1790638341	45 Count	224 Count	40 Count
1790637140	20 Count	107 Count	19 Count
1790635939	214 Count	1088 Count	185 Count
1790634738	196 Count	984 Count	169 Count
1790633538	173 Count	873 Count	150 Count
1790632337	154 Count	778 Count	133 Count
1790631136	131 Count	679 Count	113 Count
1790629935	112 Count	585 Count	97 Count
1790628734	98 Count	512 Count	85 Count
1790627532	81 Count	437 Count	71 Count
1790626332	61 Count	334 Count	53 Count
1790625131	42 Count	255 Count	37 Count
1790623930	28 Count	168 Count	25 Count
1790622729	12 Count	72 Count	11 Count
1790621528	214 Count	1012 Count	119 Count
1790620328	198 Count	915 Count	106 Count
1790619127	188 Count	793 Count	99 Count
1790617926	179 Count	709 Count	91 Count
1790616742	164 Count	634 Count	81 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)