APRS Track Direct

My position About ☰

reset

JR2YQN-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JR2YQN-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732391704	129	61	255	182	143
1732389878	130	61	255	183	144
1732388078	129	62	255	182	143
1732382624	130	62	255	182	143
1732380825	129	62	255	182	143
1732368113	130	65	255	182	143
1732366313	130	65	255	181	142
1732364484	130	65	255	182	143
1732362684	130	66	255	181	142
1732360886	130	66	255	181	142
1732360854	130	66	255	182	142
1732359054	130	67	255	181	141
1732353588	130	68	255	181	141
1732349991	130	70	255	180	140
1732342656	130	82	255	177	136
1732340857	130	89	255	174	132
1732339059	130	94	255	173	130
1732338990	130	94	255	173	131
1732337190	130	96	255	172	129
1732335322	130	96	255	173	130
1732333523	130	93	255	173	130
1732331724	130	89	255	175	133
1732331667	130	88	255	175	133
1732329867	130	85	255	176	134

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)