APRS Track Direct

My position About ☰

reset

SR9WXW Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9WXW. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx10min*	Vbatt*
1790642299	24 Pkt	10.76 V
1790640941	11 Pkt	10.78 V
1790639162	10 Pkt	11.74 V
1790637989	11 Pkt	12.62 V
1790636817	7 Pkt	12.8 V
1790635643	11 Pkt	12.84 V
1790634471	9 Pkt	12.86 V
1790633301	18 Pkt	12.84 V
1790632127	15 Pkt	12.84 V
1790630954	11 Pkt	12.86 V
1790629781	10 Pkt	12.88 V
1790628608	8 Pkt	12.88 V
1790627435	10 Pkt	12.94 V
1790626263	12 Pkt	12.9 V
1790625090	10 Pkt	12.9 V
1790623921	12 Pkt	12.92 V
1790622746	9 Pkt	12.94 V
1790621569	14 Pkt	12.96 V
1790620396	10 Pkt	12.94 V
1790619224	8 Pkt	12.96 V
1790618051	16 Pkt	12.96 V
1790616882	7 Pkt	12.94 V
1790615706	8 Pkt	13.02 V
1790614534	15 Pkt	12.96 V
1790613363	5 Pkt	12.92 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)