APRS Track Direct

My position About ☰

reset

N8QH-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N8QH-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732306687	523	152	263	169	194
1732306380	521	152	255	169	195
1732306072	523	170	263	169	193
1732304842	522	165	370	169	195
1732304228	524	163	258	169	195
1732303613	523	171	259	169	194
1732303305	523	169	256	169	194
1732302692	521	166	254	169	195
1732302074	521	161	265	169	195
1732301458	523	155	257	169	195
1732300230	522	172	261	168	195
1732299923	518	166	261	269	197
1732299308	521	166	257	168	194
1732299000	523	173	382	170	194
1732298693	521	148	265	169	195
1732298078	522	184	263	169	195
1732297771	521	173	257	169	195
1732297156	519	158	368	170	195
1732295926	528	178	266	169	195
1732295004	528	155	262	168	298
1732294697	525	165	255	169	195
1732294390	528	146	268	168	195
1732294082	526	152	269	168	195
1732293468	526	159	270	259	197
1732292239	521	173	268	169	194

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)