APRS Track Direct

My position About ☰

reset

YD1ION-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD1ION-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1732483577	-71 dBm	21 V
1732481755	-69 dBm	21 V
1732479865	-69 dBm	21 V
1732478042	-70 dBm	21 V
1732476151	-67 dBm	21 V
1732474329	-68 dBm	21 V
1732472438	-70 dBm	21 V
1732470616	-71 dBm	21 V
1732468725	-71 dBm	21 V
1732466903	-72 dBm	21 V
1732465012	-68 dBm	21 V
1732463190	-69 dBm	21 V
1732461299	-73 dBm	21 V
1732458264	-69 dBm	21 V
1732456374	-69 dBm	21 V
1732453338	-71 dBm	21 V
1732451448	-71 dBm	21 V
1732449626	-68 dBm	21 V
1732447735	-68 dBm	21 V
1732445913	-70 dBm	21 V
1732444022	-67 dBm	21 V
1732442200	-68 dBm	21 V
1732440308	-69 dBm	21 V
1732438486	-69 dBm	21 V
1732436595	-71 dBm	21 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)