APRS Track Direct

My position About ☰

reset

EA5SW-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5SW-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274262	0 Count	26 Count
1774123026	16 Count	141 Count
1774120386	15 Count	141 Count
1774117745	14 Count	141 Count
1774115105	13 Count	141 Count
1774112464	12 Count	141 Count
1774109823	11 Count	141 Count
1774109347	10 Count	141 Count
1774106707	9 Count	141 Count
1774104066	8 Count	141 Count
1774101426	7 Count	141 Count
1774098785	6 Count	141 Count
1774096144	5 Count	141 Count
1774093504	4 Count	141 Count
1774090863	3 Count	111 Count
1774088223	2 Count	83 Count
1774087749	1 Count	83 Count
1774085109	0 Count	35 Count
1774082468	272 Count	1026 Count
1774079828	271 Count	997 Count
1774077187	270 Count	984 Count
1774074546	269 Count	984 Count
1774071906	268 Count	984 Count
1774069265	267 Count	984 Count
1774066625	266 Count	984 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)