APRS Track Direct

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770131769	49 Count	510 Count	28 Count
1770130868	46 Count	473 Count	26 Count
1770129967	44 Count	446 Count	25 Count
1770107482	65 Count	760 Count	48 Count
1770106581	64 Count	751 Count	48 Count
1770105681	62 Count	728 Count	47 Count
1770104780	56 Count	680 Count	42 Count
1770103879	51 Count	618 Count	38 Count
1770102979	48 Count	597 Count	36 Count
1770102078	47 Count	586 Count	36 Count
1770101177	41 Count	531 Count	31 Count
1770100276	40 Count	515 Count	31 Count
1770099375	35 Count	458 Count	27 Count
1770098474	30 Count	410 Count	23 Count
1770097574	25 Count	348 Count	19 Count
1770096673	23 Count	320 Count	18 Count
1770095772	18 Count	262 Count	14 Count
1770094872	16 Count	214 Count	13 Count
1770093971	10 Count	133 Count	8 Count
1770093070	6 Count	71 Count	5 Count
1770092170	3 Count	34 Count	3 Count
1770091269	106 Count	1005 Count	80 Count
1770090368	101 Count	959 Count	76 Count
1770089468	97 Count	904 Count	73 Count
1770088567	92 Count	809 Count	69 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)