APRS Track Direct

My position About ☰

reset

DA0YFD-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DA0YFD-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786807094	213	222	0	128	5
1786806888	212	216	0	128	5
1786806654	210	208	7	128	6
1786806517	209	204	11	255	8
1786806417	208	200	3	128	10
1786806279	207	194	8	255	13
1786806178	207	190	3	128	15
1786806033	206	184	6	255	20
1786805933	205	180	6	128	22
1786805783	204	178	5	255	25
1786805683	202	172	13	128	26
1786805683	202	172	13	128	26
1786805532	202	168	8	255	27
1786805532	202	168	8	255	27
1786805431	201	164	11	128	29
1786805283	199	160	8	255	32
1786805283	199	160	8	255	32
1786805182	197	156	16	128	33
1786805182	197	156	16	128	33
1786805026	195	148	13	255	38
1786805026	195	148	13	255	38
1786804925	193	144	13	128	43
1786804925	193	144	13	0	43
1786804786	191	136	17	0	50
1786804786	191	136	17	255	50

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)