APRS Track Direct

My position About ☰

reset

K5AGO-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K5AGO-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786659143	139	96	255	88	68
1786648304	123	107	255	99	77
1786647702	123	106	255	100	78
1786647401	124	105	255	100	78
1786647100	124	104	255	101	78
1786646799	124	104	255	101	79
1786646498	125	104	255	101	78
1786645895	135	104	255	96	75
1786645618	122	103	255	102	79
1786645317	123	103	255	102	79
1786644715	124	102	255	103	80
1786644414	124	102	255	103	80
1786644113	125	102	255	103	80
1786643812	139	102	255	102	79
1786643509	122	100	255	103	81
1786642908	122	99	255	104	81
1786642606	123	98	255	104	81

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)