APRS Track Direct

My position About ☰

reset

SP4SAS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SAS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1786787495	325 Count	667 Count	288 Count
1786786594	320 Count	661 Count	284 Count
1786785694	315 Count	653 Count	280 Count
1786784793	307 Count	643 Count	273 Count
1786783892	301 Count	632 Count	268 Count
1786782991	296 Count	626 Count	264 Count
1786782090	292 Count	619 Count	261 Count
1786781190	285 Count	605 Count	255 Count
1786780289	280 Count	596 Count	251 Count
1786779388	273 Count	588 Count	245 Count
1786778488	257 Count	566 Count	230 Count
1786777587	240 Count	549 Count	214 Count
1786776686	234 Count	541 Count	209 Count
1786775785	226 Count	529 Count	202 Count
1786774885	219 Count	517 Count	196 Count
1786773984	213 Count	507 Count	191 Count
1786773083	204 Count	483 Count	183 Count
1786772182	193 Count	444 Count	173 Count
1786771282	178 Count	406 Count	159 Count
1786770381	148 Count	346 Count	130 Count
1786769480	136 Count	308 Count	119 Count
1786768580	130 Count	284 Count	114 Count
1786767696	111 Count	248 Count	100 Count
1786766795	99 Count	215 Count	89 Count
1786765895	88 Count	187 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)