APRS Track Direct

My position About ☰

reset

YB1DDK-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB1DDK-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1744123807	-77 dBm	5.46 V
1744122885	-76 dBm	5.46 V
1744121963	-76 dBm	5.43 V
1744121041	-76 dBm	5.43 V
1744120119	-77 dBm	5.46 V
1744119197	-75 dBm	5.46 V
1744118275	-74 dBm	5.37 V
1744117353	-74 dBm	5.5 V
1744116431	-75 dBm	5.46 V
1744115509	-75 dBm	5.41 V
1744114587	-73 dBm	5.43 V
1744113665	-74 dBm	5.48 V
1744112743	-75 dBm	5.46 V
1744111821	-74 dBm	5.46 V
1744110899	-74 dBm	5.43 V
1744109977	-75 dBm	5.43 V
1744109055	-74 dBm	5.5 V
1744107211	-74 dBm	5.41 V
1744106289	-76 dBm	5.41 V
1744105366	-74 dBm	5.37 V
1744104444	-75 dBm	5.48 V
1744103522	-77 dBm	5.48 V
1744102601	-76 dBm	5.43 V
1744101678	-75 dBm	5.37 V
1744100756	-76 dBm	5.43 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)