APRS Track Direct

My position About ☰

reset

W1FN-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W1FN-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786719179	135	86	136	117	111
1786717378	133	84	137	117	112
1786715578	133	82	137	118	113
1786713778	133	82	137	118	113
1786711978	132	82	137	118	113
1786710178	132	81	137	118	113
1786708378	131	78	137	119	114
1786706579	131	77	137	119	115
1786704781	131	77	137	119	115
1786702983	131	77	137	119	116
1786701179	131	77	137	119	115
1786699379	131	77	137	119	115
1786697579	131	77	137	119	115
1786695777	131	77	137	119	115
1786693979	131	78	137	119	115
1786692178	131	79	137	119	115
1786690378	131	79	137	119	115
1786688578	131	79	137	118	114
1786684979	131	80	137	118	114
1786683179	131	82	137	118	115
1786681379	131	82	137	118	115
1786679579	131	82	137	118	115
1786677780	131	83	136	117	114
1786675981	131	84	136	117	114
1786674183	131	86	136	117	113

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)