APRS Track Direct

My position About ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790658090	81 Count	503 Count	62 Count
1790656289	77 Count	480 Count	59 Count
1790654489	73 Count	457 Count	56 Count
1790652688	69 Count	435 Count	53 Count
1790650887	65 Count	409 Count	50 Count
1790649086	61 Count	381 Count	47 Count
1790647295	57 Count	352 Count	44 Count
1790645494	53 Count	330 Count	41 Count
1790643693	49 Count	302 Count	38 Count
1790641893	45 Count	279 Count	35 Count
1790640092	41 Count	254 Count	32 Count
1790638291	37 Count	231 Count	29 Count
1790636490	30 Count	199 Count	23 Count
1790634690	26 Count	178 Count	20 Count
1790632889	22 Count	153 Count	17 Count
1790631088	19 Count	135 Count	15 Count
1790629288	15 Count	110 Count	12 Count
1790627487	11 Count	84 Count	9 Count
1790625693	7 Count	49 Count	6 Count
1790623892	3 Count	26 Count	3 Count
1790622092	172 Count	1016 Count	136 Count
1790620291	168 Count	993 Count	133 Count
1790618490	164 Count	970 Count	130 Count
1790616690	160 Count	943 Count	127 Count
1790614889	153 Count	912 Count	121 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)