APRS Track Direct

My position About ☰

reset

SP8SD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786786255	231 Count	424 Count	197 Count
1786785954	227 Count	416 Count	194 Count
1786785653	221 Count	405 Count	189 Count
1786785352	213 Count	392 Count	182 Count
1786785052	210 Count	387 Count	180 Count
1786784751	204 Count	379 Count	175 Count
1786784451	197 Count	366 Count	169 Count
1786784150	192 Count	358 Count	165 Count
1786783852	187 Count	344 Count	161 Count
1786783549	179 Count	331 Count	154 Count
1786783248	173 Count	320 Count	149 Count
1786782948	170 Count	317 Count	147 Count
1786782647	153 Count	287 Count	131 Count
1786782347	150 Count	279 Count	129 Count
1786782046	139 Count	261 Count	119 Count
1786781745	128 Count	237 Count	109 Count
1786781445	122 Count	224 Count	104 Count
1786781144	119 Count	218 Count	102 Count
1786780844	111 Count	205 Count	95 Count
1786780242	102 Count	190 Count	88 Count
1786779941	94 Count	175 Count	81 Count
1786779641	89 Count	166 Count	77 Count
1786779340	83 Count	155 Count	72 Count
1786779040	78 Count	147 Count	68 Count
1786778739	73 Count	139 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)