APRS Track Direct

My position About ☰

reset

PY2PWL-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY2PWL-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	VBAT*
1790679788	-54 dbm	3.05 V
1790677988	-50 dbm	3.06 V
1790676188	-44 dbm	3.06 V
1790674388	-50 dbm	3.06 V
1790672588	-49 dbm	3.06 V
1790670788	-47 dbm	3.06 V
1790668988	-49 dbm	3.06 V
1790667188	-50 dbm	3.06 V
1790665388	-50 dbm	3.06 V
1790663588	-51 dbm	3.06 V
1790661788	-47 dbm	3.06 V
1790659988	-47 dbm	3.06 V
1790658188	-49 dbm	3.06 V
1790656389	-52 dbm	3.06 V
1790654588	-54 dbm	3.06 V
1790652788	-52 dbm	3.06 V
1790650988	-44 dbm	3.06 V
1790649188	-47 dbm	3.06 V
1790647388	-49 dbm	3.06 V
1790645588	-50 dbm	3.06 V
1790643788	-51 dbm	3.06 V
1790641988	-54 dbm	3.06 V
1790640188	-50 dbm	3.06 V
1790638388	-53 dbm	3.05 V
1790636588	-52 dbm	3.06 V

*Used Equation Coefficients:

RSSI: 0, -1, 0

VBAT: 0, 0.01, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)