APRS Track Direct

My position About ☰

reset

SR2ZYT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZYT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790695567	223	548	159	421	275
1790693768	220	539	157	421	275
1790691969	215	521	153	422	276
1790690169	207	509	146	422	276
1790688371	204	503	144	422	276
1790686571	201	497	142	422	276
1790684774	198	491	140	423	277
1790682975	195	485	138	423	276
1790681176	192	479	136	426	275
1790679377	186	470	131	417	276
1790677577	183	464	129	417	275
1790675780	180	458	127	417	277
1790673981	177	452	125	417	276
1790672182	174	446	123	417	276
1790670381	171	440	121	417	276
1790668581	168	434	119	417	275
1790666781	165	428	117	416	275
1790664982	162	422	115	417	218
1790663183	159	416	113	417	217
1790661382	156	410	111	415	218
1790659584	153	404	109	415	220
1790657785	148	395	105	415	46
1790655986	145	384	103	415	0
1790654187	142	374	101	415	0
1790652388	139	364	99	415	0

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)