APRS Track Direct

My position About ☰

reset

SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786732153	399 Count	453 Count	399 Count
1786730353	388 Count	440 Count	388 Count
1786728553	380 Count	429 Count	380 Count
1786726753	373 Count	420 Count	373 Count
1786724953	363 Count	408 Count	363 Count
1786723153	335 Count	378 Count	335 Count
1786721353	310 Count	351 Count	310 Count
1786719553	291 Count	330 Count	291 Count
1786717753	273 Count	310 Count	273 Count
1786715953	261 Count	296 Count	261 Count
1786714153	248 Count	282 Count	248 Count
1786712352	238 Count	270 Count	238 Count
1786710552	226 Count	255 Count	226 Count
1786708752	216 Count	243 Count	216 Count
1786706952	207 Count	232 Count	207 Count
1786705152	195 Count	218 Count	195 Count
1786703352	187 Count	208 Count	187 Count
1786701552	168 Count	187 Count	168 Count
1786699752	140 Count	156 Count	140 Count
1786697952	111 Count	126 Count	111 Count
1786696152	99 Count	112 Count	99 Count
1786694352	89 Count	99 Count	89 Count
1786692552	79 Count	88 Count	79 Count
1786690751	69 Count	77 Count	69 Count
1786688951	43 Count	49 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)