APRS Track Direct

My position About ☰

reset

OK1JRA-16 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1JRA-16. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1749396417	7	7	49	4	53.33
1749395516	19	19	157	3	53.33
1749394614	6	6	119	2	53.33
1749393714	5	5	49	1	53.33
1749392813	4	4	49	0	53.33
1749391912	5	5	49	95	53.33
1749391011	4	4	49	94	53.33
1749390110	6	6	54	93	53.33
1749389208	6	6	49	92	33.33
1749388307	7	7	119	91	53.33
1749387407	4	4	49	90	53.33
1749386505	6	6	51	89	53.33
1749385604	2	2	16	88	53.33
1749384704	5	5	49	87	31.11
1749383802	6	6	119	86	53.33
1749382901	6	6	119	85	53.33
1749382001	3	3	49	84	53.33
1749381099	5	5	119	83	53.33
1749380199	4	4	49	82	53.33
1749379297	20	20	119	81	53.33
1749378396	11	11	119	80	53.33
1749377495	23	23	119	79	53.33
1749376594	28	28	120	78	35
1749375693	6	6	67	77	53.33
1749374792	32	32	119	76	53.33

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)