APRS Track Direct

My position About ☰

reset

OK0BAF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0BAF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786742909	70	51	121	360	67
1786742009	78	52	121	360	67
1786741110	91	56	122	360	67
1786740209	76	55	124	360	67
1786739309	61	40	125	360	67
1786738410	71	45	121	360	67
1786737509	62	46	121	360	67
1786736610	74	51	121	360	67
1786735709	66	48	122	360	67
1786734810	74	51	121	360	67
1786733910	57	48	121	360	67
1786732109	68	51	121	360	67
1786731210	74	52	121	360	67
1786730310	69	50	122	360	67
1786729410	66	45	122	360	67
1786728510	73	50	122	360	67
1786727610	77	52	123	360	67
1786726710	70	50	123	360	67
1786725810	76	53	124	360	67
1786724910	70	52	122	360	67
1786724011	60	50	123	360	67
1786723110	67	47	123	360	67
1786721310	71	46	124	360	67
1786720412	81	55	123	360	67

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)