APRS Track Direct

My position About ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786784158	160 Count	709 Count	89 Count
1786783857	157 Count	700 Count	88 Count
1786783556	156 Count	698 Count	88 Count
1786783255	153 Count	692 Count	87 Count
1786782954	151 Count	685 Count	86 Count
1786782653	149 Count	681 Count	86 Count
1786782353	147 Count	678 Count	85 Count
1786782052	144 Count	668 Count	84 Count
1786781751	143 Count	666 Count	84 Count
1786781451	140 Count	658 Count	83 Count
1786781150	138 Count	651 Count	82 Count
1786780849	136 Count	647 Count	82 Count
1786780548	134 Count	643 Count	81 Count
1786780248	131 Count	634 Count	80 Count
1786779947	130 Count	632 Count	80 Count
1786779646	127 Count	624 Count	79 Count
1786779346	123 Count	608 Count	76 Count
1786779045	119 Count	588 Count	74 Count
1786778744	111 Count	569 Count	67 Count
1786778443	105 Count	548 Count	63 Count
1786778143	96 Count	531 Count	55 Count
1786777842	91 Count	518 Count	52 Count
1786777541	88 Count	510 Count	50 Count
1786777240	86 Count	506 Count	50 Count
1786776940	84 Count	502 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)