APRS Track Direct

My position About ☰

reset

HR1AHR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HR1AHR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*
1739739202	180	13	1	92
1739737585	180	13	1	95
1739735543	180	11	1	96
1739733985	181	12	1	95
1739731883	180	17	2	97
1739730385	180	14	2	97
1739728223	180	13	2	96
1739726785	180	13	2	96
1739724563	180	10	2	95
1739723185	180	10	2	91
1739720903	180	11	2	89
1739719585	180	10	2	90
1739717243	180	13	2	97
1739715985	180	13	2	97
1739713583	180	12	2	93
1739712388	180	10	2	90
1739709923	180	10	2	89
1739708785	180	10	2	91
1739706263	180	11	2	91
1739705185	180	12	2	93
1739702603	180	19	2	97
1739701586	180	17	2	97
1739698944	180	12	2	93
1739695284	164	14	1	90
1739691624	180	14	2	91

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)