This is the latest recevied telemetry packets stored in our database for station/object XE1EL-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time | Value1* | Value2* | Value3* | Value4* | Value5* |
---|---|---|---|---|---|
1718391523 | 135 | 77 | 255 | 178 | 160 |
1718387921 | 136 | 75 | 255 | 178 | 160 |
1718384319 | 143 | 75 | 255 | 178 | 159 |
1718380718 | 140 | 74 | 255 | 178 | 158 |
1718377114 | 138 | 72 | 255 | 177 | 158 |
1718373513 | 130 | 72 | 255 | 177 | 158 |
1718369911 | 124 | 72 | 255 | 177 | 157 |
1718366310 | 118 | 73 | 255 | 176 | 157 |
1718362708 | 123 | 74 | 255 | 176 | 156 |
1718359107 | 123 | 75 | 255 | 176 | 155 |
1718355503 | 123 | 76 | 255 | 175 | 155 |
1718351901 | 124 | 77 | 255 | 175 | 155 |
1718348300 | 124 | 79 | 255 | 175 | 154 |
1718344698 | 124 | 80 | 255 | 175 | 154 |
1718341096 | 125 | 82 | 255 | 174 | 154 |
1718337495 | 125 | 83 | 255 | 174 | 154 |
1718333893 | 126 | 83 | 255 | 174 | 154 |
1718330291 | 122 | 84 | 255 | 175 | 154 |
*Used Equation Coefficients:
Value1: 0, 1, 0
Value2: 0, 1, 0
Value3: 0, 1, 0
Value4: 0, 1, 0
Value5: 0, 1, 0
- The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
- Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value2 + b * value + c. - The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
- The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
- All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
- A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)